Valve Tightening

•  Deflate the board and remove the valve cover cap.  

.

•  Open your orange patch kit and take out the valve wrench. 

• Insert the valve wrench into the valve assembly and tighten by turning clockwise.

• Warning: Do not over-tighten! 
• Warning: Do this while board is deflated! If you turn the wrong way, the valve assembly will shoot out of the board and cause injury.

• Replace the valve cap and re-inflate your board. Check for hissing. 
• (Note: Never use a screwdriver to tighten the actual valve at the center of the valve assembly)